The safety operation process of the servo control system of

The mechanical displacement servo control system can output (or angular displacement) to accurately track the input (or angle), able to control the power load with small power, when the oil paper frame of the paper usually system can track well controlled, so that the output of paper cutting machine scoring Zhang Pinghang, vertical; servo control the system can through the hydraulic electric machine and a series of feedback is delivered to the system, through the system analysis, processing and feedback.

The servo control system of once the film cutting machine were safe operation, need to follow the following process:

1, check the machine equipment is normal and the roller clean.

Die and blade 2, installed in the corresponding position with the required diaphragm is equal to the width of the mold and the blade, no oil, dust, rust and other necessary sharp blade.

3, rolling paper sleeve mounted on the winder shaft.

4, will need to be cut, the diaphragm diaphragm is fixed on the frame behind the machine, the diaphragm must be fixed, not to move around and up and down.

5, will open the blade position alignment diaphragm separated into required size small diaphragm, which is fixed to the cylinder sleeve. It is necessary to cut the diaphragm shaft. The die, the blade shaft and the reel must be flat.

6, turn on the power switch, start the machine, try cutting, testing whether meet the required size requirements. Related reading: the film cutting machine operates four parts: feeding, film dressing, conjunctiva and blanking.

　　Through the above understanding, you should have a more understanding of coating machine, laminating machine, gravure printing press, Slitter, if you have other questions, you may contact our online customer service:+86-13958857367。